Valentino Rockstud Ballerina

[numbo beras]

How to Cover Valentino Rockstud Ballerina the Kitchen Table With Flashing

Multiply the edge measurement by 2 and add it to the table top dimensions. For instance, if the side measures 1 1/2 inches, you will add 1 inch to that measurement (2 1/2 inches) and multiply it by 2 (5 inches total). Add that total to the measurement of the table top, so if the table top measures 3 feet by Valentino Shoes Sale 2 feet, then your final dimensions will be 3 feet 5 inches by 2 feet 5 inches. This final measurement will determine the size for the piece of metal flashing you will use to cover the table.

Center the flashing on the table and on the underside draw a line with a marker or pencil that will help you to Valentino Online lay it correctly when you are attaching it to the surface. You might prefer to trace the entire table or only mark out one or two sides.

Lay the flashing on the glued surface of the table, using the guide(s) you drew to make sure it is centered the first time, if possible. The adhesive should start setting within 10 minutes, so you won't have much time for doovers.

Wait 15 to 20 minutes to allow the flashing to adhere to the tabletop.

Cut each of the four corners of the flashing with the tin snips. Start at the point of each corner and cut diagonally in to the corner of the table.

Bend the flashing down over each side edge of the table. Doing this is very similar to wrapping a present. You should have enough extra to bend the flashing under the side edge so that the visible edge of your table covering will be smooth. You may find it helpful or even necessary to use the hammer to assist in bending the flashing, especially when you are folding it under the side edge.

Secure the flashing to the table with the screws using the power screwdriver. Place the screws so that they are about 1/8 inch from the edge of the flashing on the underside of the table edge. Put two screws in each of the shorter sides of the table and three screws in each of the longer sides of the table.

If there are sharp edges on the corners of the table, use the hammer to Valentino Flats Sale pound them down and smooth them out.

Flashing comes in different grades or thicknesses. You will want to select one that is thick enough to be durable yet not so thick that you cannot work with it.

If Valentino Shoes the flashing sheets are far bigger than you need, you can either cut them to the correct size with the tin snips, or the hardware store where you purchase it may have someone on staff who can cut it for you.

Have someone help you center the flashing before you glue it down. He can Valentino Boots hold it in place as you trace the outline. He can also help when it is time to lay it on the gluecovered surface.