the board stressed

[hhm1020]

Observation of the board stressed that the strength of the board is finger to feel the plate surface fastness. Side of the material should be well-shaped frame to fixed, if sparse matrix, a press surface will feel the void is not real, large panel fibrillation; Drawer bottom hand to push in order to test strength, generally the end of multi bulkhead laminates, large area bulkheads should be of five board production. Door and drawer switch to be flexible.

Panel covered with veneer and other materials, surface, and color should be similar sets of products, product surface coating does not allow wrinkled skin, hair paint adhesion and leakage. Check whether the stability and safety of a drawer or door frame tilt, the availability of eye position contorted or eyelets tenon is too large, loose tenon and other parts caused by the low level of technology skew. Wooden furniture to have security and stability, when the two doors open 90 degrees, the hand gently pull forward, the cabinet should not automatically forward tipping; glass bookcase door to go through the milling treatment; full-length mirror and dressing Taiwan To install the rear plate, layering the glass surface should be fixed. Individual furniture parts (eg legs, drawer, door or frame, etc.) must be sufficient load bearing capacity. You should nudge furniture upper corner or sitting on the side, try furniture is solid. Check that the interface should buy using a dovetail or butterfly engagement furniture. Heavy furniture should be in the corner with a protective screw block, and stick well. As part of the backplane must also check whether the insert is good, and Shang Hao screws.

Check the drawer slides and drawers should be strong and solid bolt, tighten the screw on the inside. Might opened the drawer and Active Desktop, doors, etc., to ensure ease, and properly connected. Check the surface of the hand on the surface of furniture, carefully check the polished surface is smooth, especially to view the table legs and other parts are rough, whether brushing paint streak, whether angular position of the pigment coated too thick, cracks or air bubbles . Furniture should "inverted" chairs and the pad surface of the furniture upside down and see how they are made. As for the table, from the bottom of the check. To see if the seams reinforced with screws and wedges? Slats and crosspiece Snap close it? There is no excess glue joints and fillers.